How to tune a cb radio with a built in swr meter

How do you fix a high SWR on a CB radio?

If your antenna is mounted down low on the vehicle, like on the bumper or behind a pickup truck’s cab, the signal can bounce back to the antenna, causing a high SWR. To alleviate this, keep at least the top 12 inches of the antenna above the roof line, and position the antenna as high as possible on the vehicle.

Does coax length affect SWR?

Many antennas have a SWR of just over a perfect match like a SWR of 1 to 1.2. This is measured at the antenna itself. With a length of coax the SWR will now show a SWR of say 1 to 1.0 , because of the loss in the coax. And so will the bandwidth change a little.

What is an acceptable SWR reading?

What is a good SWR reading ? The best reading possible is 1.01:1 (46dB return loss), but usually a reading below 1.5:1 is acceptable. Outside the perfect world a 1.2:1 (20.8dB return loss) is spot on in most cases. To ensure an accurate reading, it is best to connect the meter at the base of the antenna.

Can SWR be too low?

An SWR too low over the whole band (1:1 for all 40 channels) can indicate a low efficiency antenna or lossy component. … If you have an antenna that’s say, three feet or less, and the SWR tunes great (less than 1.5) across all the channels than maybe your antennas feedline coax or the antenna coil is “lossy”.

How do I increase the signal strength on my CB radio?

How to Increase the Receiving Range on a CB Radio

  1. Install an antenna specifically manufactured for use with CB radios. …
  2. Place your antenna as high as possible, in a place where radio signals can hit it from 360 degrees. …
  3. Adjust the squelch on your radio so that it blocks out static, but is not maxed out.
You might be interested:  What radio station is the cavs game on

What does S RF mean on CB?

transmitted radio signal power

Why can’t people hear me on my CB?

Make sure the connections are tightened. Ensure that the microphone pins on the radio are making a connection with the microphone plug. … Be sure you are pressing the CB microphone button all the way in. If it is a power mic or echo mic, make sure there is a battery in it!

Can high SWR damage a radio?

High SWR can reflect enough power back into the radio to create enough heat to cook the final RF transistor. It isn’t usually an immediate failure, it takes some time for that heat to build up and do damage.

What causes high SWR on CB?

One of the most common causes of high SWR readings is incorrectly connecting your SWR meter to your radio and antenna. When attached incorrectly, readings will be reported as being extremely high even if everything is installed perfectly.

What does a very high SWR reading mean?

What does a very high SWR reading mean? The transmitter is putting out more power than normal, showing that it is about to go bad. The antenna is the wrong length, or there may be an open or shorted connection somewhere in the feed line. There is a large amount of solar radiation, which means very poor radio conditions.

Does a CB radio antenna need to be grounded?

Ground Your Antenna Mount

If you’re using a standard CB antenna (i.e., anything except a no ground plane, or NGP, kit), you’ll need to make sure your antenna mount is solidly grounded to the vehicle’s chassis. A bad ground will result in an un-tunable antenna and sky-high SWR levels.

Leave a Reply

Your email address will not be published. Required fields are marked *