How to enter acura radio code

How many digits is Acura radio code?

10 digit

Why does my Acura says Enter code?

Step inside the cabin of your Acura vehicle and turn the vehicle on. The radio should still say “CODE” — that simply means the security system kicked on because it lost power from your battery.

How do I get the code for my Acura Navigation?

How to Find the Lost Code for an Acura Navigation System

  1. Dial the Acura Customer Service Number: 1-800-382-2238 to unlock your navigation system and assign you a new security code.
  2. Provide Customer Service with the requested information for VIN, Navigation Unit Serial Number and ownership Information. …
  3. The customer service agent will assign you a new PIN code.

How can I bypass the code on my car radio?

Without the Unlock Code

  1. Call your car manufacturer directly. Your car manufacturer’s phone number is in your owner’s manual. Ask to be connected to the support department. …
  2. Enter the code and unlock your stereo. Use the code you received from the manufacturer to unlock and and activate your car stereo.

How do you unlock a factory radio?

Step 1: Start the vehicle and turn on the radio. The radio will display “LOC” indicating the Theftlock system is activated. Step 2: Press and hold preset buttons 1 and 4 for ten seconds. (If you don’t have a fourth preset button, press and hold presets 2 and 3.)

How do I reset my Acura TL security system?

Insert the ignition key and turn it to the on position and then attempt to start the engine (crank over), the engine wont start. With the key still in the run position wait 10 minutes and the security light should blink and then go out. Turn the key off and wait 5 seconds.

You might be interested:  How to wire a radio

How do I reset my Acura Navigation?

Honda/Acura Navigation Reset

  1. Hold down the Menu+Map/Guide+Cancel buttons for about 5 seconds (the “Select Diagnosis Items” screen will appear).
  2. Hold down the Map/Guide button for 5-10 seconds (A screen with a “Complete” button, will appear).
  3. Touch “Complete,” and then the “Return” button (the system may re-boot).

Leave a Reply

Your email address will not be published. Required fields are marked *