How to install amp with factory radio

Where is the factory amp located?

FACTORY AMP LOCATIONS: The Amplifier is located under the rear seat on the passenger side.

What is the best line output converter?

Without any further ado, let’s get to it.

  1. AudioControl LC2i PRO 2 Channel Line Out Converter – Best Line Out Converter. …
  2. AudioControl LC7i 6-Channel Line Output Converter – Most Versatile Line Out Converter. …
  3. Kicker KISLOC 2-Channel Line Out Converter – Best Beginner’s Line Out Converter.

Can you install an amp without RCA jacks?

Hook-Up Amp Using Line Output Converter(LOC)

A line output converter speaker level signals to RCA signals that are used by an amplifier. … You can use this method to hook up your amp without RCA jacks. Before you start the installation, find the leads connecting your factory radio and amplifier to speakers.

Can you bypass a factory amp?

AudioControl does not recommend bypassing the factory amp when using any of our factory integration products, such as our line converters and DSP processors. … Typically the head unit sends the audio signal to the factory amp, and the amp does all the processing and volume control.

How do I know if my factory amp is bad?

How do you Figure Out that your Car Amplifier is not Working Properly?

  1. There is a noticeable distortion in the sound.
  2. There is no sound even if you have already turned on your audio system.
  3. Your stereo system starts making bizarre sounds such as farting sounds.

How do I connect subwoofer to speaker level output?

Be sure your receiver can run both ‘A’ and ‘B’ speakers simultaneously. 2. For subwoofers equipped with a speaker-level input and a speaker-level output, simply connect the receiver speaker outputs to the speaker-level input on the subwoofer and the speaker-level output of the subwoofer to your speakers.

You might be interested:  What is jango radio

How do you hook up a subwoofer without an amp?

Hooking Up a Subwoofer Without an Amplifier

Start the installation process by removing your speaker from the mounting dock, giving access to its wiring. Mount your subwoofer in your preferred location. Next, reroute the stereo and power supply cables to the subwoofer and connect them.

How do you wire an amp to a head unit?

Wiring It In

  1. Cut the insulation off the end of all the wires and leave enough space to attach connector plugs. …
  2. Connect the ground wire to a metal point connected to the car’s chassis or a dedicated grounding point. …
  3. Plug your RCA leads, speaker leads and remote turn-on lead from the amp into the back of the head unit.

Can you hook up a subwoofer to a factory radio?

…it takes amplified speaker level signals and converts them into high quality preamp signals that can be fed into an amplifier. … So now you know – it’s definitely possible to install a subwoofer and amplifier to your factory system, and still have it sounding good.

Can I connect a subwoofer to a stereo?

The most common method is done by connecting the subwoofer to the SUB OUT or LFE output of a receiver/amplifier. But you might also come across a subwoofer that uses stereo RCA or speaker wire connections. If your receiver or amplifier has enough variety, you should be able to handle most any subwoofer out there.

Leave a Reply

Your email address will not be published. Required fields are marked *